Simple flasher on one transistor

Pin
Send
Share
Send

There is a strong need to make the LED blink, in order to enhance the attraction of human attention to the signal. But to make a complex scheme, there is simply no time and place to place radio elements. I will show you a circuit consisting of only three, which will make the LED blink.

The circuit works well from 12 volts, which should interest motorists. If we take the full range of the supply voltage, then it lies in the range of 9-20 volts. So the applications of this device can find a lot.

This is truly a super simple circuit to make the LED blink. Of course, there is a large electrolytic capacitor in the circuit, which can steal a lot of space, but this problem can simply be solved using a modern elemental base, such as an SMD capacitor.

Note that the base of the transistor is hanging in the air. This is not a mistake, but a circuit design. The base is not used, since the reverse conductivity of the transistor is used in the work.

Such a flasher can be assembled by hinged installation for about fifteen minutes. Dress the heat shrink tubing and blow the hot air gun. And now you have a generator blinking LEDs. The flashing frequency can be changed by increasing or decreasing the capacitance of the capacitor. The circuit does not need to be configured and works immediately with serviceable circuit elements.
The flasher is very economical in operation, reliable and unpretentious.
USB soldering iron

Pin
Send
Share
Send

Watch the video: supper led blinking flasher circuit using one transistor (November 2024).