Eraser "Marshmallow"

The original “Marshmallow” jewelry will make even a simple pigtail a charming and bright hairstyle.
To create a gum "Marshmallow" should be prepared:
- an elastic band for hair of yellow color.
- silicone rods and glue gun.
- 5 cm wide satin ribbons in yellow and white.
- rhinestones with a diameter of 2 mm.
- a lighter.
- yellow cabochon.
- scissors.
Creating a marshmallow decoration.
From tapes of white and yellow it is necessary to make equilateral parts in the form of squares. The sides of the parts must be equal to the width of the tapes, at least 5 cm.
Of the yellow ribbon, 16 squares will be required, and of the white tape 24 parts. Then, it is required to make triangles from the details of each shade of ribbons, folding them along a diagonal line.
Now the details must be superimposed one on top of the other, with a white triangle on top and a yellow one on the bottom. Be sure to ensure that the fold lines of the two parts coincide.
Holding the combined triangles with your fingers, you must arrange their fold lines horizontally. Then the corner of the right edge should be bent to the center of the part, directing to the lower corner.
Then you need to repeat the sequence when adding the right side of the part.
It turns out a rectangular blank with two sides of the slices. They must be leveled, cutting off small irregularities and processing the lighters with fire to solder the tapes.
From the remaining 15 yellow and 15 white squares, the same petals should be created. A total of 16 parts are required for the flower.
Then the corner of one petal should be put in the middle of the second, smearing glue in front of this side. Gradually pasting the sides of the petals into the center of the previous part, it is necessary to form a small circle out of them.
There are 8 white squares left, of which petals should be made for the middle of the decoration. To do this, from the blanks of a white ribbon, it is necessary to make the petals, repeating the above description.
It is not necessary to singe sections with fire; the part must be bent along the central lines.
Now the corners should be slightly cut, creating a right angle relative to the fold lines. A new edge must be scorched, processing from shedding.
4 mm should be stepped off the bend lines, excess petal depths should be cut off, and the edges scorched thoroughly.
It turns out a petal in the form of a droplet.
From the remaining 7 squares of white braid you need to create the same details.
White petals now need to be glued together to create a circle.
It turns out a small white flower, it must be located in the center of the yellow circle, pre-lubricated with glue.
Then a circle will be required from the yellow ribbon, which will gently hide the underside of the prepared jewelry.
This circle must be treated with glue and attached to the inside of the flower.
Next, you should attach the prepared yellow elastic band to the decoration, having previously determined the middle of the flower.
Now you need to fix the yellow center in the center of the white flower, and small rhinestones along the edges of the petals.
Decoration "Marshmallow" is ready!

Watch the video: Ed Sheeran - Eraser Official Audio (November 2024).